1. Installation process
1. INSTALLATION PROCESS
About this chapter
This chapter describes how to replace the (universal) lamp house from the FLM projector.
Adapted software for Universal Lamp House
The
FLM projector software
must be upgraded to version
1.7.17
or later prior to using the Universal Lamp House. The latest FLM
projector software can be downloaded from the Barco secured web site
https://my.barco.com
(browse to the product page of the
FLM projector). The FLM projector will not recognize the Universal Lamp House and will fail to start up the xenon bulb lamp when
neglecting this software upgrade. Use the Projector Toolset, which is also available on the secured Barco web site, to upgrade the
projector software. See user guide of the Projector Toolset for detailed instructions on how to upgraded the projector software.
Overview
•
•
•
•
Installation of the lamp house
•
Installation of the lamp cover
1.1
Switching off
How to switch off the projector?
1. Press
fi
rst
Standby
.
2. Let cool down the projector until the fans decrease, at least 5 min.
3. Switch off the projector with the power switch.
1.2
Removal of the lamp cover
W
ARNING
:
This procedure may only be performed by quali
fi
ed technical service personnel.
Necessary tools
7 mm
fl
at screw driver.
How to remove the lamp cover of the projector ?
1. Release the two captive screws at the top and bottom right side of the lamp cover, using a
fl
at screw driver.
R5976922 FLM LAMP HOUSE 18/11/2008
1
