Barco F80-Q12, Руководство пользователя

Страница: 47 / 210

47 R5906852 /09 F80
Nb.Name Pcs
Description Purpose
8 DP 2 Standard display port For Projector Input
9 DL-DVI-D 2 Dual DVI-I 1.0 (DVI_D
Functionallity). For Projector Input. These connectors can also
be used to form one uniform image by feeding
half of the image into each connector. HDCP
compliant for sources up 165 Mhz
10 HDMI 1 Standard HDMI 2.0 For Projector Input
11 HDBaseT 1 Standard RJ45 8P8C
Connector For Projector Input
12 SDI 2 SDI1 is Input, SDI 2 is pass
through. (out) For Projector Input
Regarding the Trigger Output: If these outputs are loaded too heavy, there is a risk that the projector
will go in reset mode, and restart. This causes no damage to the projector, but is an undesirable
response. This will also happen if the startup current for the external equipment is too high, even
though the nominal power consumption is less than 0,5A.
4.3 Making connections
The source switching time is variable and could take few seconds..
Source signal connectivity
The connector panel at the back of the projector is used for all source connections.
Source signal connectivity on the projector is:
• 2x Dual Link DVI-I (DVI-D functionality)
• 2x DisplayPort 1.2
• 1x HDMI 2.0
• 1x HDBaseT
• 1x SDI input (initially designed for 3G-SDI input signals, 12G-SDI signals are now supported)
4.4 LED and Button indication chart
Button Backlight Status
Button Color status
Description
Standby button Blinking WHITE (slow) Projector starts up (booting)
Blinking WHITE (fast) Firmware upgrade
Solid WHITE Projector is in Standby mode
Blinking BLUE Projector goes to ON mode
Solid BLUE Projector is ON
Blinking RED Error condition
Shutter button Off (no color) Projector is OFF, starts up, or is in
Standby mode.
Solid WHITE Projector is ON, shutter is open
Solid RED Projector is ON, shutter is closed
Input & Communication