Barco F70 - W6, Руководство пользователя

Страница: 51 / 74

6. Source menu
6. SOURCE MENU
About the Source menu
This menu is used to select, review and con fi gure sources into the projector. Enables either via the source menu, or the shortcut key.
By navigate through the Home/Source menu, it will be visible also on the OSD.
By using the shortcut key, the menu occurs only on the LCD display.
Overview
• Connector selection
• Connector Settings
• Using Dual DVI or Dual Display Port
6.1 Connector selection
About
Source / {Source}
Click on the relevant input connector icon to swap or activate the source.
The icon for the active source is highlighted.
The list of displayed sources can be adjusted to include other connectors.
The default selection of connectors displayed is:
• DVI 1
• DVI 2
• Dual DVI
• Display Port 1
• Display Port 2
• Dual Display Port
• HDBaseT
• HDMI
• SDI
6.2 Connector Settings
About
Home/Source/ConnectorSettings
The Connector settings menu allows to change settings for the DVI, Display Port, HDMI, HDBaseT and SDI inputs. Default value
are set to Auto. When entering the menu for each input, there are some selectable choices.
6.3 Using Dual DVI or Dual Display Port
Dual Head Input.
For extended fl exibility to connect high resolution sources with a pixel clock over 330 MHz, the projector is supporting a dual head
input mode. In this mode, the left and the right half of the image can be connected to the DVI-I1 and DVI-I2 respectively, or DP1
and DP2.
To enable this mode, select the source menu Source — Dual DVI (or Dual DP) .
It is important to set up the signal source in dual mode with the correct resolution,
601–426 F70 SERIES 16/06/2017 47