Barco F70 - W6, Руководство пользователя

Страница: 48 / 74

5. Getting started
5.1.3.1 RS-232
Speci fi cations
Parameter Value
RS-232 connector 1 female DB9 connector (RS232-in) for projector control and
debug
5.1.3.2 LAN/Ethernet
Speci fi cations
Parameter Value
Ethernet connector 1 RJ45 Connector for projector control (not content)
Protocols DHCP, TCP/IP, UDP/P
Speed 10/100 Mbit/1000Mbit
5.1.3.3 USB-A port
Speci fi cations
Parameter Value
USB connector Type A
Function Firmware upgrade using USB sticks
Power Power 5V, max 1,5A (out)
Standard USB 2.0
5.2 Power up the projector
C
AUTION
:
Sources should always be connected before the projector is powered up
C
AUTION
:
Use only power cords following the unit, designed for your projector model. Do not use unautho-
rized replacements. Do not use power cords which are damaged.
Power up the projector using the keypad or remote
1. Connect the line cord to the projector.
2. Plug the 3–pronged cord into a grounded AC outlet.
The projector will begin warming up, and the backlight of the Standby /power button are fl ashing white.
3. When the backlight on the standby button are constant white, the projector are in standby mode, ready to be switched on.
4. Press the standby button on the keypad or the power button on the remote to bring the projector up to standby mode.
The power button backlight on the keypad will fl ash blue while the projector is warming up.
5. When the power button backlight is steady blue, the projector is ready for use.
5.3 Power down the projector
Power down using the keypad or remote
1. Depress and hold the power button on the keypad or remote for four (4) seconds.
The Projector is now in cooling down phase.
2. When the projector panel is no longer illuminated, remove the mains power cord from the projector.
44 601–426 F70 SERIES 16/06/2017