Barco F70 - 4K6, Руководство пользователя

Страница: 35 / 136

601 – 426-03 F70 Series 35
When using wired remote control, the broadcast address must be set to “ Generic ID (0) ” . See the menu in
“ Enable / Disable Remote Control ” , page 34.
It is not possible to program the remote control in wired mode. (Directly connected, no sense in programming).
2.8 Projector Address
Projector address
Address installed in the projector to be individually controlled.
Broadcast address
Projector will always execute the command coming from a RCU programmed with that broadcast
address.
2.8.1 Controlling the projector
Why a projector address?
As more than one projector can be installed in a room, each projector should be separately addressable with
an RCU or computer. Therefore each projector has its own address.
Set up an individual Projector Address
The set up of a projector address can be done via the software.
Projector controlling
When the address is set, the projector can be controlled now:
• with the RCU: only for addresses between 1 and 31.
Broadcast Address
Every projector has a broadcast (common) address '0' or '1'. The default address is '0'.
The choice between '0' and '1' can be selected in the GUI: “ System Settings ” → “ Communication ” →“ IR Control
“ .
Placing new batteries in the remote control or plugging the remote to a projector via a cable will
automatically reset the address back to its default value '0'.
2.9 Connector panel
General
The source input panel is located at the back of the projector. For source specifications, see table below.
Image 2-10
Name Pcs
Description Purpose
DMX IN 1 DMX 512 input For Projector Control
DMX OUT 1 DMX 512 output For Projector Control
Getting to know the projector.