1. Remove the projector lens.
2. Use the mounting screws
(2)
to mount the baseplate
(1)
to the underside
of the projector.
3. Loosen the 2 connection screws on the lens ring bracket and remove the
upper lens ring bracket
(6)
.
4. Check that the shim
(4)
position is correct for the type of lens you are
using.
5. Loosely mount the lower lens ring bracket
(5)
to the sliding rail
(3)
. Do
not over tighten.
6. Replace the projector lens. If required, adjust the lens settings.
7. Replace the upper lens rings bracket
(6)
and tighten the 2 connection
screws firmly.
8. Tighten the lower lens ring/sliding rail screws firmly.
6
5
3
4
2
1
Item
Description
1
Baseplate
2
Mounting screws (4 pcs M6 x 12)
3
Shim
4
Sliding rail
5
Lower lens ring bracket
6
Upper lens ring bracket
•
Use caution when tightening screws. Applying too much force may
cause damage to the lens or lens support.
•
It is recommended that zoom, focus and iris positions are locked using
their respective Z-lock screw (
tool: 1.5mm allen key
) before mounting
the lens support.
•
Lens shift should be disabled in the projector (service) menu
after mounting the lens support kit. Contact your Barco service
representative for assistance if required.
Lens Support Kit
General advice
Procedure
Installation
EN52, EN54
EN521 EN53,
EN55, EN56,
EN57
EN51, EN53,
EN55, EN56,
EN57
EN52, EN54,
Mounting on different lenses
Before mounting the lens support kit on the EN52 and EN54 lenses, the
lower lens ring bracket should be rearranged so that the shim is on the side
furthest from the projector.
