Barco F400, Руководство пользователя

Страница: 46 / 220

R5915525 /00 Fx400 Series 46
Typical life time of the projector could be up to double if the laser output is dimmed to 75% and if the
projector operate in 25°C temp condition.
4.9 Operation in 24/7 Mode
General
When the projector is destined to be operated continuously 24 hours a day, 7 days a week, the following
recommendations should be followed:
• Twice a day, switch off the projector during two minutes by using the power button. The power down action
will automatically and invisibly trigger a grey test pattern running within the projector.
• Apply moving video content as much as possible, with on average a level of 50% white (long-term use of
extreme black or white content could potentially cause accelerated aging).
4.10 Projector Address
Projector address
Address installed in the projector to be individually controlled.
Broadcast address
Projector will always execute the command coming from a RCU programmed with that broadcast
address.
4.10.1 Controlling the projector
Why a projector address?
As more than one projector can be installed in a room, each projector should be separately addressable with
an RCU or computer. Therefore each projector has its own address.
Set up an individual Projector Address
The set-up of a projector address can be done via the software.
Projector controlling
When the address is set, the projector can be controlled now:
• with the RCU: only for addresses between 1 and 31.
Broadcast Address
Every projector has a broadcast (common) address '0' or '1'. The default address is '0'.
The choice between '0' and '1' can be selected in the GUI: “ System Settings ” → “ Communication ” → “IR
Control “.
Placing new batteries in the remote control or plugging the remote to a projector via a cable will
automatically reset the address back to its default value '0'.
4.11 Quick setup via Direct access
Quick source selection
1. Press the Input button on the remote control or local keypad.
Getting started