Barco F400, Руководство пользователя

Страница: 45 / 220

45 R5915525 /00 Fx400 Series
Image 4–6 Example of a status menu
4.7 Power off projector
How to Switch off the projector
1. Use the Power On / Off , or the Power Off button on the remote control, to switch off the projector.
The projector will switch to READY mode first in order to run through a cool down phase.
2. If Standby ECO mode is enabled in the service menu (refer to the section "GUI - system settings/Standby
ECO", in User Guide) the projector will automatically go to
Standby ECO mode after a time-out (default 15
minutes).
Some actions like apply a grey test pattern are done during the two minutes of the cool down phase
in order to minimize the potential effect of burn-in and increase the projector lifetime.
CAUTION: Never switch off the projector by means of unplugging mains cord or by cut down of
mains power.
Barco advises to keep the projector always powered and use the ECO mode for low power
consumption.
How to unplug the projector
1. Follow the procedure above to Switch Off the projector.
2. Wait at least 2 minutes prior to unplug the projector by removing the power cord from the AC outlet.
CAUTION: It is very important to wait few minutes before unplugging the power cord. If the cool
down phase is not adhered, projector lifetime could be degraded.
4.8 Increasing the projector lifetime
General
Barco propose the following recommendations to increase the projector life time:
• Dimming out the laser output intensity (70%).
• Use the device in regulated temperature area.
• Apply the recommendations describe in the “Operating in 24/7 Mode” chapter if the projector is destined to
be operated continuously 24 hours a day / 7 days a week.
Getting started