Barco Event Master E2, Руководство пользователя

Страница: 174 / 307

7. System Setup
7.13 Con fi guration Menu > Add Outputs
General
In this procedure, you will add Outputs to the system .
Prerequisite
• Ensure that you are familiar with the Con fi guration Menu . For details on this menu, please refer to chapter "Con fi guration
Menu", page 76
If more than one Output is utilized, repeat the below steps until all inputs are added and adjusted.
Add Output
1. Click on the Output tab to select the outputs that will be de fi ned.
2. Click on the +Add Output blue button to enter the Add mode.
3. Click on the connector that the display device is connected to add it as an output.
4. Click on the Done Adding button to exit the Add mode.
(Optional) Edit the Name
1. Double click on default name in the Name list to edit the name.
2. When the area turns blue, click the eraser icon to clear the fi eld.
3. Type a new name.
(Optional) Adjust Output Parameters
Click on the Adjust tab that is located on the top. From this menu you can adjust:
1. Edit the name.
2. Select Format value, color space and connector type.
3. Enable Test Patterns with raster box and enable diagonal motion.
4. De fi ne the Area of interest (AOI).
5. Perform color adjustments.
6. Read all timing parameters associated with the selected format.
7. Select SDI type and SMPTE standards.
8. Adjust HDMI parameters.
(Optional) Auto create Outputs
If the Auto create Outputs is pressed, then the software will add all unassigned outputs to the output list and number them sequen-
tially. This button is a shortcut for systems utilizing a large number of outputs.
(Optional) Delete Outputs
1. Click on the blue button Delete Output(s) .
2. From the Name list click on the “ x ” space next to the Output(s) you wish to delete.
3. Hit the red button Delete Output(s) button. All of the selected Outputs will be removed from the list.
170 R5905948 E2 12/12/2014