Barco Event Master E2, Руководство пользователя

Страница: 171 / 307

7. System Setup
7.10 Con fi guration Menu > Initial Setup
General
In this procedure, you will run the Event Master Control Software, verify communication between the E2 and the program to the local
network and perform basic setup.
Prerequisite
• Ensure that you are familiar with the Con fi guration Menu . For details on this menu, please refer to chapter "Con fi guration
Menu", page 76
Setup
1. Connect the PC running the Event Master Control Software to the same local network switch that the E2 is connected to. Run the
Event Master Control Software and the software should connect to E2 automatically. The unit is listed in the System con fi guration
page under the Discovered tab with the button on turning green.
2. Drop the E2 from the device area into the middle diagram area.
3. If multiple units are connected to the PC, the green LEDs next to the system will turn green. You can assign a unique name
to each unit. You can con fi rm that you are connected to the right unit by clicking the arrow in front of E2 to reveal the unit’s IP
address. Verify that this address is the same as the address listed on the unit’s front panel on the top status menu.
Note: If the unit doesn’t connect automatically to the PC, you can type the PC’s IP address in the fi eld under “Manual Connect”.
4. (Optional) Select E2’s native vertical refresh rate from the “Native Rate:” drop down menu. Default value is 60Hz.
5. (Optional) Select E2’s native layer mode from the “Mode: ” drop down menu. Default value is2K (HD).
6. (Optional) Select E2’s Genlock mode from “ Genlock ” drop down menu. Default value is OFF .
R5905948 E2 12/12/2014 167