Barco Duet II, Руководство пользователя

Страница: 13 / 65

3. Connections
Image 3-4
LCD Display
When entering the Adjustment Mode the menus are displayed on top of the projected image and on the LCD
display of the BARCO Duet II. Only the menus displayed on top of the projected image are mentioned in this
manual.
How to switch the Duet II Off?
1. Press the power switch to switch the BARCO Duet II Off.
Note: Wait until the message ’Saving Data’ on the LCD Display disappears, to switch ’Off” the Duet II, otherwise the latest
adjustments will not be saved.
3.4 Input Connection
How to connect to the 5–Cable Input?
1. Connect the BNC’s from the stereo source signal output cable, to the 5–Cable Input on the BARCO Duet II. (image 3-5)
Image Generator
Barco Duet II
MAINS
COMMUNICATION
STEREO ID BIT IDENTIFICATION
G B H/C G B H/C
G B H/C
DVI OUT DVI OUT
RS 232 IN RS 232 OUT
INPUT
R V
TO PROJECTOR 2
R V
TO PROJECTOR 1
R V
Image 3-5
Input Connection
3.5 Connections to the Projectors
Introduction
Some general “Duet II” setups are described in the following connection procedures, in these setups we assume that the Left Polar
is used on Projector 1 and the Right Polar is used on Projector 2.
R5976550 BARCO DUET II 10/05/2007 9