Barco DP2K SLP Series, Руководство по обслуживанию

Страница: 354 / 410

R5906848 /04 DP2K SLP Series 354
Group 20187: “ LCM 1 – Air drawn in temperature sensor open ”
Situation Solution
Temperature sensor
unplugged Check / reseat temperature cable on the LCB (J406).
Defective LCB Replace the Laser Control Board (LCB). See service procedure “ Replacing
the Laser Control Board (LCB) ” , page 64.
Malfunctioning temperature
sensor Replace the Light Source. See procedure “ Laser Phosphor Light Source ” ,
page 59.
Code 20240: “ LDM 1 – 15 vm voltage too low ”
Situation Solution
Malfunction Laser Driver
Module Replace the LDM. See service procedure “ Replacing a Laser Drive
Module ” , page 56.
Code 20243: “ LDM 1 – 15 VM voltage too high ”
Situation Solution
Malfunction Laser Driver
Module Replace the LDM. See service procedure “ Replacing a Laser Drive
Module ” , page 56.
Code 20244: “ LDM 1 – 380 vm voltage too low ”
Situation Solution
Malfunction Laser Driver
Module Replace the LDM. See service procedure “ Replacing a Laser Drive
Module ” , page 56.
Code 20247: “ LDM 1 – 380 vm voltage too high ”
Situation Solution
Malfunction Laser Driver
Module Replace the LDM. See service procedure “ Replacing a Laser Drive
Module ” , page 56.
Code 20248: “ LDM 1 – 380 vma voltage too low ”
Situation Solution
Malfunction Laser Driver
Module Replace the LDM. See service procedure “ Replacing a Laser Drive
Module ” , page 56.
Code 20251: “ LDM 1 – 380 vma voltage too high ”
Situation Solution
Malfunction Laser Driver
Module Replace the LDM. See service procedure “ Replacing a Laser Drive
Module ” , page 56.
Troubleshooting