Barco DP2K-E series, Руководство пользователя и инструкция по установке

Страница: 62 / 163

8. ICMP
8.5 ICMP reset button and status LEDs
ICMP status LEDs and Reset button
LEDs on ICMP front panel give information on the status of the device.
1
2
3
Image 8-8
Status overview PWR/ERROR and READY LEDs:
1 2
PWR/ERROR READY ICMP Status
Off Off Turned off
Red
Off
Board reset
Blinking Green Off Boot loader
Blinking Green Blinking Orange Operating System start up
Blinking Green Orange Security Manager - Image Integrity tests
Blinking Green Blinking Yellow Security Manager - Self Test
Blinking Green Yellow Security Manager - FPGA self-test
Green Blinking Orange Update ongoing
Green Blinking Green FIPS ok - Application startup
Green Green Power on & No Error
Blinking Red Off FIPS error
3
Reset button
Button used to reset ICMP (reference 3 image 8-8)
C
AUTION
:
It is not recommended to use the ICMP reset button if conventional means to stop and restart the
ICMP are always available. It is an ultimate resort in the event of complete blockage of interface.
C
AUTION
:
In case the ICMP is installed in a RGB-laser illuminated cinema projector it is recommended to put
the lasers in deconditioning state before pressing the reset button and condition them again from the moment
the ICMP is rebooted (after reset). Resetting the ICMP with lasers on can create a risk as the proper operation
of the DMD cooling cannot be guaranteed in this case.
58 R5906693 DP2K-E SERIES 19/06/2015