![background image](http://html1.mh-extra.com/html/barco/dp2k-e-series/dp2k-e-series_safety-manual_4092214007.webp)
1. Safety
1.3
Product safety labels
Product safety labels
Label image
Label description
Label location
The Lamp House is very hot after operation. To avoid
burns, let the projector cool down for at least 15 minutes
before proceeding to remove the Lamp House.
General Warning Hazard
Electric Voltage Hazard
Hot Surface Hazard
UV Hazard
Hazardous moving parts.
Keep away from moving fan blades.
Keep
fi
ngers and other body parts away.
On the fans inside the projector
1.4
Light beam Hazard Distance (HD)
HD
Light beam Hazard Distance (HD) is the distance from the source at which the intensity or the energy per surface unit
becomes lower than the applicable safety limit. The light beam can thus be considered as dangerous if the operator
is closer from the source than the HD.
Restriction Zone (RZ) based on the HD
The HD is de
fi
ned from the projection lens surface towards the position of the lowest projected beam where the irradiance equals
the applicable safety limit. The HD depends on the amount of lumens produced by the projector and the type of lens installed. See
next chapter
HD in function of the lens Throw Ratio (TR)
.
To protect untrained users the installation shall comply with the following installation requirements: light output levels in excess of the
limits shall not be permitted at any point less than 2.0 meters (SH image 1-1) above any surface upon which persons are assumed
to stand or 1 meter (SW image 1-1) below or in lateral separation from any place where such persons are assumed to be. See
image 1-1.
R5906695 DP2K-E SERIES 19/06/2015
5