Barco DP2K-12C, Руководство по установке

Страница: 59 / 111

7. Communicator touch panel
7. COMMUNICATOR TOUCH PANEL
Overview
• Introduction
• Installing the touch panel interface
• Reposition the touch panel interface
7.1 Introduction
Communicator Touch Panel for digital cinema projectors
The Communicator Touch Panel is designed for multi-user command and control, the Communicator enables users to learn quickly
and operate ef
fi ciently - using an elegant and fl exible touch panel interface. The interface’s commonality means that operators
can intuitively use any model in the product line, without restriction, and its user-friendly nature translates directly into a short and
enjoyable learning curve.
Image 7-1
Flexible touch panel interface
The touch panel interface can be mounted upon a swivel arm which easily fi ts on top of the DP2K C-series projector. One central
locking mechanism of the swivel arm allows an instant fi xation of the touch panel interface in any position.
The touch panel interface can also be installed further away from the DP2K C-series projector. For that you can use a serial (RS232)
cable up to 10 meter or an Ethernet cable up to 50 meter to allow a direct data communication between the DP2K C-series projector
and the Communicator Touch Panel.
The touch panel interface can also be connected with a Local Area Network (LAN) just like the DP2K C-series projector. In this case
both devices can communicate with each other as well.
The touch panel interface requires a +12 VDC voltage, 1,5 ampere. The use of a se12 VDC adaptor (1,5 ampere minimum)
is required.
Parts location of the touch panel interface
A
B
C
D
E
F
G H
Image 7-2
Communicator touch panel
R5905050 DP2K C-SERIES 10/07/2012 53