Barco Demetra, Руководство пользователя

Страница: 20 / 68

K5902200 /07 Barco Demetra 20
Install the non-contact cone on the head of the Demetra Scope. The notch in the non-contact cone must be
fitted on the secondary camera. The non-contact cone is held in place safely through a magnetic attachment.
2.3.4 Charging the Demetra Scope
Procedure
1. Connect the adapter to the battery charging station. Route the adapter cable through the notch at the
bottom of the battery charging station to put the charging station in a stable position.
2. Place the adapter plug for your country (USA, EU or UK) into the adapter such that the plug fits into the
foreseen slots. Slide the plug downwards until it clicks.
3. Plug the adapter into the socket.
4. Place the complete Demetra Scope (with grip installed) or the separate grip in the battery charging station.
Make sure that the notches at the bottom of the grip are properly installed on the protrusions of the battery
charging station. The complete Demetra Scope (with grip installed) or the separate grip is held in place
safely in the battery charging station through a magnetic attachment.
5. The LED on the grip slowly blinks green during charging. As soon as the LED is steady green, charging is
complete.
Complete charging time (from empty batteries to fully charged batteries) is approximately 3 hours.
For use only with the delivered adapter: model ATM012T-W051V, Adapter Technology Co., Ltd.
The Demetra Scope head also includes a battery. To charge the full battery capacity, install the
complete Demetra Scope (with grip installed) in the battery charging station.
Install the battery charging station on a flat, stable surface near an easily accessible socket. Make
sure the adapter cable is routed towards the socket in a safe way to avoid damage to the cable and/
or charging station.
2.4 Setup of Demetra Scope
2.4.1 Configuration
Procedure
For the initial setup of your Demetra Scope (and also for fluent synchronization of data from the
Scope to the cloud), a good WiFi connection is required (see
“ Minimum system requirements ” , page
12 for more information).
The Demetra Scope batteries must be fully charged before initial setup. Charge for a minimum of 2
hours before initial use.
First perform the configuration (as admin) procedure of the Demetra Web Application (see
“ Configuration (admin) ” , page 13 ).
1. Press the On/Off button to turn on the Demetra Scope. The welcome screen will be shown.
2. Check to make sure that the grip is attached to the head of the device and the locking ring is fully closed,
then proceed to the next step.
3. Follow the instructions on the display screen to link your device to your customer account (organization).
4. Scan the QR code shown in the Demetra Web Application with the Demetra Scope.
5. Once the QR code is scanned successfully, the Demetra Scope needs to be connected to a WiFi network.
6. When the WiFi connection is established, the device automatically performs a network connectivity check.
7. The device checks for software updates, and if available, downloads and installs those updates. This may
take a few moments.
Installation and configuration