Barco DCS-200, Руководство пользователя

Страница: 81 / 170

DCS-200 • User’s Guide 81
4. Operation
Using the Setup Menu
To clear the message and continue operations, press ESC .
aá~ÖåçëíáÅë
From the System Menu , select Diagnostics to display the Diagnostics Menu :
Figure 4-55. Diagnostics Menu
If you suspect a problem with the DCS-200, press SEL to run a series of internal diagnostic
tests. The menu will report back “ PASS ” or “ FAIL .”
p~îÉ=póëíÉã=pí~íÉ
From the System Menu , select Save Config to save all current “system” settings so that
they may be restored at power up. A message is briefly shown, after which the DCS-200
returns to the
System Menu .
Figure 4-56. Saving System Configuration Message
Please note the following important points regarding the system configuration file:
•
When you perform the Save Config function, all configuration parameters from
the System Menu are saved in non-volatile memory. If you do not perform the
function, data will not be restored upon the next system power up sequence.
•
This command also saves the current input as the default power-up selection.
Note This message is a warning only, which does not prevent the
operation of the DCS-200. If this message appears, it is
recommended that you contact Barco Customer Service.
D I A G N O S T I C S
> S E L = S t a r t T e s t s
Note If the menu reports “ FAIL ,” contact Barco Customer Service.
In Appendix C, refer to the “ Contact Information ” section on
page 160 for contact details.
S a v i n g S y s t e m C o n f i g . . .
Note If you want the DCS-200 to always power up and acquire an
input other than input
1 , perform the Save System State
command while the desired input is selected on Program.