Barco DCS-200, Руководство пользователя

Страница: 26 / 170

26 DCS-200 • User’s Guide
2. Hardware Orientation
DCS-200 Rear Panel
3) HD/SD SDI Input
One BNC connector is provided for the SD-SDI or HD-SDI input.
4) Main Outputs
Two connectors are provided for the DCS-200’s main program outputs. Both
outputs have the same resolution, and both can be used simultaneously.
~
One DVI-I connector is provided for the system’s digital program output.
There are no analog outputs on this connector. In Appendix A, refer to
the “
DVI-I Connector ” section on page 119 for pinouts.
~
One HD-15 connector is provided for the system’s analog output. In
Appendix A, refer to the “
Analog 15-pin D Connector ” section on
page 118 for pinouts
5) Serial
One DB-9 connector is provided for Serial communications with the DCS-200
system. The port is also used for diagnostics or command-line operations.
6) Ethernet
One RJ-45 connector is provided for 10/100BaseT Ethernet communications with
the DCS-200 system. The port is used for running the built-in web-based GUI, for
diagnostics, or for command-line operations via Telnet (using port 23).
S
telnet 192.168.0.10 23
In Appendix A, refer to the “ Ethernet Connector ” section on page 120 for
pinouts.
7) AC Power
One AC Connector is provided for connecting DCS-200 to AC. The integral
switch turns the chassis on and off. In Appendix A, refer to the “ Physical and
Electrical Specifications ” section on page 117 for power details.
8) Preview Outputs
Two outputs are provided for connecting to the Preview monitor: an HD-15
connector for analog monitors and a DVI connector for digital displays.
Note The DVI-I connector allows you to use both DVI-D and DVI-I
cables as required.