88
DCS-200 • User’s Guide
4. Operation
Using the LOGO
rëáåÖ=íÜÉ=ildl
A
logo
is a full-screen video source which, when transitioned to Program, appears on top
of all other sources. The DCS-200 can store up to three logos in non-volatile memory.
The DCS-200 enables you to transition to or from a full-screen logo, in the same way that
you transition to or from video inputs. When you press
TAKE
,
the system transitions the
selected logo to or from Program at the current transition rate, and the sources flip-flop in
the manner described in the “
” section on page 85.
Please note the following important points:
•
If a source
and
a key are already on Program, both will dissolve out as the logo
dissolves in. The figure below illustrates this transition:
Figure 4-62.
Transition to LOGO from Source Plus Key
•
If a key is enabled in the input source, and you save the source as a logo, the key
becomes part of the stored logo.
•
A logo will be labeled
INVALID
if it was captured at a resolution that does not
match the current output resolution The resolution at which it was captured will
also be displayed — e.g.,
[INVALID 1600x1200].
•
If you scroll to an invalid logo, the
LOGO
button cannot be activated. The
following message will appear.
Figure 4-63.
LOGO Output Resolution Message (sample)
•
If
LOGO
is selected when there are no saved or valid logos, the following
message will appear:
Figure 4-64.
LOGO Error Message (sample)
T h i s s t o r e d L O G O d o e s
n o t m a t c h t h e c u r r e n t
o u t p u t r e s o l u t i o n .
P l e a s e c a p t u r e a g a i n .
N o s a v e d o r v a l i d
l o g o s a v a i l a b l e
f o r d i s p l a y
Input 1
LOGO
Black
Transition Time
Video
Mix
Digital Key Source
Содержание DCS-200
Страница 1: ...r d a pJOMM Manual 26 0604010 00 Revision 00...
Страница 114: ...114 DCS 200 User s Guide 6 Upgrading Software Ethernet Upgrade Method...
Страница 126: ...126 DCS 200 User s Guide K p Format Table...
Страница 158: ...158 DCS 200 User s Guide _K o Remote Commands...