Barco D320, Руководство пользователя

Страница: 13 / 29

3. Physical Installation
3. PHYSICAL INSTALLATION
3.1 Installation requirements
Requirements
• The Digitizer should not be placed in a built-in installation or enclosure unless proper ventilation is provided.
• When using the unit in a multi-unit rack assembly or closed assembly, the ambient temperature inside the assembly may not
exceed the maximum rated ambient temperature of the Digitizer. The installation should be such that the amount of air flow
required for safe operation of the equipment in not compromised.
• When building in the Digitizer into a rack with cover door, be aware that a space of 8,5 cm is needed between the indicated
reference and the cover door. This space is needed to guide the input cables to the inputs.
Image 3-1
A Reference
• The Digitizer will require that air flows freely in vent holes. Blocking these holes will greatly reduce the reliability of the unit and
lead to the possibility of overheating.
• The Digitizer should operate from an AC power source. The Digitizer is equipped with Power Supply Autoranging from 90 to
264 volt (50–60 Hertz).
• When installed in a rack, the mounting should be such that no hazardous condition is achieved due to uneven mechanical
loading.
• When the mains switch located on the back of the Digitizer is not accessible due to rack mounting, the socket outlet supplying
the rack shall be installed near the equipment and be easily accessible or a readily accessible disconnect device shall be
incorporated in the fixed wiring. When using a rack in an installation is advisable to log the serial number of the device and to
activate the warranty figure by registering utilizing the included form.
• Do not place the Digitizer on an unstable cart, stand or table. The device may fall, causing serious damage to it.
3.2 Connections
Rear panel inputs/outputs
Image 3-2
A Led-wall out
B Power Switch
C Power input
D Loop in
E Loop out
F Retractable dust filter
G RS232 in
H Reserved
I RS232 out
J Ethernet LAN connector
K Monitor out
R5976388 D320 DIGITIZER 18102002 7