Barco Coronis Uniti, Руководство пользователя

Страница: 23 / 70

23 K5902079 /11 Coronis Uniti
• “OSD menu”, page 24
• “Standby switching”, page 23
Image 3–1
To activate a shortcut bar function
1. During normal operation, press any of the front keys (except for the left-most key, which would activate I-
Luminate). The shortcut bar is activated.
2. Press the front key under a shortcut icon to activate the function.
3.3 Standby switching
To switch on your display
While in standby mode, press the right-most front key 2 times.
While starting up, the orange and white power LED are both lit, until the display is fully operational.
Make sure that the rocker switch on the power supply (next to the mains input) is in position “I” to
use your display.
To switch off your display
1. Activate the shortcut bar by pressing any of the front keys (except for the left-most front key, which would
activate I-Luminate).
2. Press the front key under the standby icon ( ).
3. Press the front key again to confirm.
In case of a power outage recovery, your display will always start-up in the power mode it was in
before the power interruption (i.e. stand-by or on). This protects your display against inadvertent
image retention problems.
3.4 SoftGlow lights
About the SoftGlow lights
The SoftGlow Task light sheds a light on the desktop, while the SoftGlow Wall light provides ambient lighting
for the reading room to reduce eye fatigue. The brightness of each is adjustable.
To use the SoftGlow lights
1. Activate the shortcut bar by pressing any of the front keys (except for the left-most key, which would
activate I-Luminate).
2. Press the front key under the SoftGlow lights icon ( ).
3. Press the front key repeatedly to cycle through the different SoftGlow light modes:
SoftGlow Task light → SoftGlow Wall light → SoftGlow Task + Wall light → OFF→ ...
To adjust the brightness of the SoftGlow lights, please refer to “SoftGlow Task light”, page 29 and
“SoftGlow Wall light”, page 30 .
Daily operation