Barco ClickShare CSE-200, Руководство по установке

Страница: 28 / 85

4. CSE-200 Installation
How to install
1. Drill two holes in the wall or ceiling as indicated on the drawing.
Horizontal distance : 162 mm,
6,5
(2x)
161,84
Image 4-1
Mounting holes
2. Insert a plug in each hole (if needed, depends on the wall or ceiling type) and drive in 2 screws. Do not drive in the screws
completely.
Note: Mounting screws and plugs are not included in the CSE-200 box . The type of screws and plugs depend on the type of
wall (stone, wood, plasterboard, ...) you are mounting the Base Unit to. Make sure the head of the screw is not larger
than the hole in the bottom plate of the Base Unit (< 6.5 mm).
3. Hook the Base Unit on both screw heads and slide the Base Unit downwards until it is fi xed.
4.4 Recommendations about antenna placement and orientation
Antenna placement rules
• The antennas should be oriented vertically, so perpendicular to the ceiling and parallel to the walls.
• The antennas should be installed far enough (at least 50cm/1.6ft) from metallic surfaces to avoid unwanted re fl ections and
far enough (at least 1m/3.3ft) from other radio equipment that operates in the same frequency range, e.g. other Wi-Fi access
points, cordless telephone, microwave ovens, …. It is also best to install antennas at least 15 cm (6 inches) from concrete walls.
• The most favorable situation is a direct line of sight between antennas and Buttons. Any obstruction will cause the signal to
follow a longer propagation path, which can result in performance degradation.
• Due to the particular radio pattern of the dipole antennas, the antennas should not be placed just above potential positions of
ClickShare users. As a result, the advised position for the antennas is at the side of the meeting room.
Image 4-2
Closer view of antennas installation in the meeting room
16 R5900023 CLICKSHARE CSE-200 13/07/2016