Barco BarcoVision R9000740, Руководство пользователя

Страница: 130 / 161

OPTIONS
R5975238 BARCOVISION 701 MULTIMEDIA 070497
OP
T
IO
N
S
OPTIONS
R5975238 BARCOVISION 701 MULTIMEDIA 070497
OP
T
IO
N
S
11-2
11-2
IR Receiver 800
This infrared receiver unit makes it possible to control the projector from another
room.
There is a communication line with cable between the IR receiver and the projector
or the RCVDS05. The control information from the RCU can now be sent to this IR
receiver.
The IR receiver 800 displays the selected source on a 7-segment display.
Order number : R9827515.
S c r e e n
C o mm u n ic atio n ca b le
B A R C O D AT A 7 0 1 S
IR R e m o te R e c eiv e r 8 0 0
P r o j e c t i o n r o o m
C o n t r o l r o o m
Hardwired RCU.
The control signals from the RCU can be sent to the projector via a wired connection.
Preparing your remote cable :
Use a shielded cable with a maximum length of 100 m and two mini-jack 3.5 mm
connectors (order number : R313043).
- Peel back the vinyl covering of the cable on both sides and twist the wire core.
- Solder a jack plug as shown in drawing above to each end of the cable.
shield
conductor
shield = ground
conductor = data information
When the cable is ready, plug one side in the remote control and the other side in
the connector on the rear of the projector labelled ‘remote’.
IR Receiver 800
This infrared receiver unit makes it possible to control the projector from another
room.
There is a communication line with cable between the IR receiver and the projector
or the RCVDS05. The control information from the RCU can now be sent to this IR
receiver.
The IR receiver 800 displays the selected source on a 7-segment display.
Order number : R9827515.
S c r e e n
C o mm u n ic atio n ca b le
B A R C O D AT A 7 0 1 S
IR R e m o te R e c eiv e r 8 0 0
P r o j e c t i o n r o o m
C o n t r o l r o o m
Hardwired RCU.
The control signals from the RCU can be sent to the projector via a wired connection.
Preparing your remote cable :
Use a shielded cable with a maximum length of 100 m and two mini-jack 3.5 mm
connectors (order number : R313043).
- Peel back the vinyl covering of the cable on both sides and twist the wire core.
- Solder a jack plug as shown in drawing above to each end of the cable.
shield
conductor
shield = ground
conductor = data information
When the cable is ready, plug one side in the remote control and the other side in
the connector on the rear of the projector labelled ‘remote’.