Barco BarcoSLM G10 Performer, Руководство пользователя

Страница: 38 / 135

4. Connections
slot 1 RGB/Component
slot 2 Video
slot 3 not used
slot 4 not used
When using a RCVDS05, it is recommended to use a 5-cable output module in the RCVDS. The outputs of this module has to be
connected to slot 1 of the projector. To switch the projector in the 5-cable mode see "Fixed slot (slot 1 & 2)", page 35.
4.5.3 Input module insertion
How to insert an input module?
To insert a module in one of the free slots, handle as follow :
1. Power down the projector and disconnect the power cord from the wall outlet.
2. Remove the dummy plate covering the chosen input slot by turning out both screws.
3. Slide the input module in the free slot. Insure the module is seated correctly in the guide grooves.
4. Press on both handles of the input module until the module plug seats in the connector of the projector. (image 4-4)
5. Secure the input module by tightening both retaining screws.
6. Reconnect the power cord to the wall outlet and switch on the projector.
OUT IN
On
R
9840450
HD SDI DIGITAL MODULE
OUT IN
On
9840110
SDI DIGITAL INPUT
COMM PORT 10/(100)BASE-T
RS232/422 OUT RS232/422 IN
IR-Receiver Diagnostic Code
Green Operation
Red Stand-by
IR Sync OK
Hardwired
remote
CTRL 1
Hardwired
remote
CTRL 2
Two way
hardwired
remote
CTRL 3
DVI INPUT
DVI INPUT
DVI OUTPUT
High Bandwidth 5 CABLE INPUT
High Bandwidth 5 CABLE INPUT
R G B H/C V
R G B V H/C
Image 4-4
34 R5976562 BARCOSLM G10 PERFORMER 20/10/2004