Barco BarcoReality 908, Руководство по установке

Страница: 35 / 74

4. Installation Setup
Scan position check
To check the scan position i.e. the orientation of the scan connectors proceed as follows:
1. Switch on the projector.
The projector starts up on the last selected source.
2. Press the ADJUST key on the RCU.
The Adjustment Mode menu will be displayed.
3. Push the
↑
or
↓
keys to highlight Service . (menu 4-1)
4. Press ENTER to select.
The Service Mode menu will be displayed.
5. Push the
↑
or
↓
keys to highlight Projector Set-Up and press ENTER . (menu 4-2)
The Projector Set-Up menu will be displayed.
6. Push the
↑
or
↓
keys to highlight Identification . (menu 4-3)
7. Press ENTER to select.
The identification screen will be displayed. This screen gives the current information about the projector configuration in the line
entitled Config. (menu 4-4)
ADJUSTMENT MODE
Select a path from below :
RANDOM ACCESS
INSTALLATION
SERVICE
Select with
↑
or
↓
then <ENTER>
<EXIT> to return
Menu 4-1
SERVICE MODE
PROJECTOR SET-UP
MEMORY MANAGEMENT
COMMON SETTINGS
I2C DIAGNOSTICS
VOLTAGE DIAGNOSTICS
PROJECTOR DIAGNOSTICS
Select with
↑
or
↓
then <ENTER>
<EXIT> to return
Menu 4-2
PROJECTOR SET-UP
IDENTIFICATION
TOTAL RUN TIME
CHANGE PASSWORD
CHANGE LANGUAGE
CHANGE PROJECTOR ADDRESS
CHANGE BAUDRATE
PROJECTOR WARM UP
POWER UP MODE: operating
COMMON ADDRESS: 0
Select with
↑
or
↓
then <ENTER>
<EXIT> to return
Menu 4-3
BARCO
REALITY 908
Proj. address: 001
Soft. Version: 2.11
Config.: Ceiling
Front
Baudrate PC: 9600
Text: ON
Serial No.: 1035895
Select with
↑
or
↓
then <ENTER>
<EXIT> to return
Menu 4-4
All projectors leave the factory set with a ceiling/front configuration.
R5976354 BARCOREALITY 908 SPLIT PACK 10092002 29