barbas Unilux-7 52, Руководство пользователя

Страница: 18 / 28

4. Remove the break strip from the baffle with a pair of pliers.
5. Do the steps 1 to 3 in opposite order to put the upper baffle in the appliance
6.3.5 General firing tips
• The appliance works best when it has heated up as described in chapter
6.3.1
.
Insufficient heating up leads to a low chimney draught, black deposits on the glass
and incomplete combustion. Good combustion is recognized by bright orange flames,
invisible smoke and no soot deposits on the glass. Use the control lever to get good
combustion. Refer to
5.1
for advice on the required fuel quality.
• Make sure the door of the appliance is closed when in use. Only open the door for
ignition and to refuel.
• Do not remove all the ashes. An ash layer in the combustion chamber forms a heat
insulating layer, that helps the fuel to ignite easy.
• Do not set the control lever in the far left position (all combustion air inlets closed)
when the appliance is used. This will cause severe smoke development, soot
formation and increases the chance of a chimney fire.
• After the first load, do not overload the appliance with fuel. Refer to
5.2
for the
recommended amount of fuel. Too much fuel leads to incomplete combustion, soot
formation and a chance of a chimney fire.
Operation
18 Unilux-7 52