barbas Unilux-7 40, Руководство по установке и обслуживанию, Страница: 24 / 48

6.2.3 Final check on the appliance
1. Make sure the door closes and opens easy.
2. Make sure the control lever moves easy to left and right without undue noise.
3. Make sure all ceramic plates, the grate and the baffles are in the correct position.
Contact your dealer if the final check shows a defect.
6.3 Installation in a new fireplace
6.3.1 Install the appliance
1. Put the appliance on the intended and correct position.
2. If applicable, connect the external combustion air supply pipe to the appliance.
To connect the optional external combustion air supply to the rear of the appliance,
refer to chapter
6.3.2
.
To connect the optional external combustion air supply to the bottom of the
appliance, refer to chapter
6.3.3
.
3. Make sure that the appliance is installed horizontally. Use a spirit level.
4. If necessary, adjust the adjustable feet. Use a 13 mm fork spanner.
6.3.2 Connect the optional external air supply (rear connection)
Note:
• The appliance has the possibility to connect a supply pipe for external
combustion air. During operation the appliance gets combustion air from
this air duct. The appliance however, is not a room-sealed appliance
according to the requirements for room-sealed appliances.
• The external air supply connection is only available when ordered with the
appliance.
• It is strongly recommended to install a valve in the external combustion air
supply pipe, to avoid debris in the pipe and to avoid water vapor
condensation in the appliance when not in use.
Installation
24 Unilux-7 40