barbas PANOLUX 52, Инструкции по применению и установке

Страница: 14 / 36

14
PANOLUX 65 PANOLUX 52
5. STOKING UP FOR THE FIRST TIME
If you have had your chimney breast modifi ed or newly built, fi rst allow your home
to dry properly. Walls which have not been allowed to dry properly are a magnet
for dust such as any smoke particles created when stoking up the fi tted fi re or
suddenly opening the door. Even scorched dust can easily be retained by damp
walls. Think also of dust on the outside of the appliance or on hot radiators etc.
Check that all packaging, stickers etc. and/or all dust and waste has been
cleaned up after the installation work (to avoid it getting scorched/causing a bad
smell).
Check again that all moving parts are in order and that loose parts such as the
brake plate, fi ns, ridling grill etc. are in the correct position. They may have moved
during installation.
The fi tted fi re has a heat-proof fi nish. It only hardens at high temperatures. When
unpacked, it is therefore not fully hardened. It can easily be damaged at this time.
Begin stoking up the fi tted fi re with a low fl ame (see section 6). Increase the heat
gradually for approx. 2 hours until you reach the correct output. Keep it at this
level for another 2 - 3 hours. The fi nish will now be properly hardened and can
be touched without damaging. The hardening process creates a nasty, though
harmless, smell/vapour.
Adequate ventilation is of the utmost importance.