barbas ECO 52, Руководство по установке

Страница: 17 / 60

17
ECO 40 / 52 / 55
Important:
• Chimneys must be free-standing, i.e. they must not rest on the appliance
itself.
• Any pipe connections that are not insulated must also be fully insulated.
• Flammable material must be kept clear (outside the casing/insulation zone)
of all through-feeds in the fl oor or wall (remember the roof decking).
• The chimney opening must be at least 5 metres above the top of the door
opening of your appliance.
• The chimney must protrude at least 40 cm above the apex of a sloping roof
and at least 1 metre above a fl at roof. In short, the chimney must always end
in an area with a negative air pressure. Contact your local chimney sweep for
the exact dimensions of the chimney opening.
Between the stove and chimney, use thick-walled smoke piping (Steel,
≥
2 mm).
See Chapter 2.2.
The fi rst pipe connected to the appliance must have a diameter of 150 mm at
both ends. This will prevent any condensation from the chimney running over
the external end of the pipe. Connect the pipes to the existing chimney (ceiling)
using a sliding sleeve (niche pipe). Check all connections for air-tightness.
If there is too much draught running through your chimney (e.g. if the chimney is
long and straight in a tall building), it may be possible to insert a chimney valve
in the pipe near the appliance. Before doing this, be sure to obtain sound advice
from a specialist.
Do not make any horizontal connections. Deposits and soot will accumulate here
(unless it is a short horizontal connection directly behind the stove).
Avoid bends at all costs. The maximum deviation from the perpendicular is 45°.
The chimney calculation, as in Germany, is made according to DIN 4705 parts
1 and 2.