Section 2. Getting Started
Figure 2. Connect Floating Cable
Align:
Key with
Notch
3.
Plug the control unit directly into a "RCD"
outlet. DO NOT use an extension cord.
NOTE:
To avoid damaging the power cable,
do not try to twist the entire cable housing (see
below).
NOTE:
To avoid exposing the power cable
connector pins to water, be sure the connector is
screwed in all the way and there is no gap. (see
below).
2.4 Connecting the Floating Cable to
the Control Box
WARNING
Failure to comply with the following warnings
can result in permanent injury, electrocution or
drowning.
PREVENT ELECTRICAL SHOCK
• Keep the control unit at least five 3.5m from the
edge of the pool.
• The cleaner is to be installed in accordance
with the relevant requirements of South African
wiring rules, or in Australia within requirements
of wiring rules AS/NZS 3000. Also refer to the
installation instructions relating to the swimming
pool equipment for which the cleaner will be an
integral part. The cleaner is to be supplied through
a Residual Current Device (RCD) with a rated
residual operating current of 30mA.
• Do not use an extension cord to connect the
control unit.
• Do not allow anyone to swim while the cleaner is
in the pool.
• The control unit is water-resistant, not waterproof.
In order to prevent electrocution, never submerge
the control unit or leave exposed to inclement
weather.
1.
Unscrew the protective cap for the floating
cable from the side of the control unit by
turning anti-clockwise (Figure 1).
Figure 1. Remove Protective Cap
2.
Align the notch in the floating cable
connector with the key in the control unit,
engage then turn clockwise to tighten.
(Figure 2.)
H0670800 5
Содержание gotcha EP34 Series
Страница 1: ...H0670800 Owner s Manual EP34 EP35...
