Baracoda BRR-L, Руководство по программированию

Страница: 5 / 33

Nextel RoadRunners Scanner Programming Guide
Last updated: 10/14/05 1 © Baracoda 2005
1 Introduction
This manual contains the necessary barcodes to configure the parameters of your scanner. You can either print
out this document to scan its barcodes or in some cases you can even scan the barcodes right off your computer
screen.
The RoadRunners scanner can be programmed by
scanning barcode labels which contain commands for the
1D decoder.
The programming labels must be Code128, with specific
starting and ending characters. These labels will always be
read, even if Code128 symbology is disabled.
Programmable options are divided into two groups:
1 Controls for the general behavior of the scanner;
2 Decoding parameters for each barcode symbology.
The scanner will acknowledge the correct and valid
reading of a programming bar code label by emitting two
beeps and both the RSL and BCL LEDs (see Figure 1) will
light up green. The scanner will emit two other beeps
(lower tone) and the red RSL LED will light up to indicate
either an invalid or incorrect reading of the programming
barcode.
CAUTION: PLEASE DO NOT READ THE PROGRAMMING BARCODES WHILE PAIRED WITH A HANDSET
OR CONNECTED TO THE BARACODAMANAGER.
Reading
Status
LED
(RSL)
Trigger
Fig. 1
Bluetooth
Connection
LED (BCL)