Baofeng UV-81C Скачать руководство пользователя страница 4

 

 

TO INSTALL BATTERY 
Place the battery bottom about 1 to 2 cm 
below the bottom of the radio's body.  

 
Make sure the battery is in parallel and in 
good contact with the aluminium chassis.  

 
Align the battery with the guide rails on the 

aluminium chassis and slide it upwards until 
a 'click' is heard.  
 

 
 
 

 
 

 
 
 

 
TO REMOVE BATTERY 
Turn off the radio before removing the 

battery.  Squeeze the battery latches, at the 
top of the battery in the direction indicated by 

the arrows. 
 
 

 
 
 

 
 
 
 
Slide down the battery for about 1 to 2 

centimetres, and then remove the battery 
from the radio's body. 

 

 

Use only the charger specified by the 
manufacturer. The charger's LED indicates 
the charging progress.  

 

WARNING: T

urn off the radio before 

charging otherwise battery will not fully 

charge. 
 

Please follow these steps:  
1.  Plug the AC connector of the power pack 

into the AC outlet socket.  

2.  Place the radio with the battery attached, 

or the battery alone, in the charger.  

3.  Make sure the battery is in good contact 

with the charging terminals. The charging 
process initiates when the red LED lights.  

4.  The green LED lights indicating the 

battery is fully charged. Remove the 
radio with the battery attached or the 

battery alone from the charger.  

 
 

BATTERY CHARGING

 

FITTING BATTERY

 

BATTERY TIPS

 

BATTERY STORAGE:  

1.  Fully charge a battery before you store it 

for a long time to avoid battery damage 

due to over-discharge.  

2.  Recharge a battery after 6 months 

storage to avoid battery capacity 

reduction due to over-discharge.  

3.

 

Store your battery in a cool and dry place 
under room temperature to reduce self-

discharge. 

 

 

 

 

 

 

 

Install the antenna as shown as below:

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

NOTE: 

-

 When installing the antenna, 

don't rotate it by its top,.  Hold it by its 

base and turn clockwise.  Don

t over

-

tighten.

 

 

If you use an external antenna, make 

sure the 'SWR' is about 1.5:1 or less to 

avoid damage to the transceiver's final 

transistors. 

 

 

 

NEVER TRANSMIT 

WITHOUT AN ANTENNA

 

 

 

 

FITTING ANTENNA

 

10 

 

 

 

 

1.  When your radio battery is getting low a 

voice prompt will indicate ‘Battery Low’.

 

2.  When charging your battery, keep it at a 

temperature between 5C and 40C.  
Temperature out of the limit may cause 

battery leakage or damage.  

3.  When charging a battery attached to a 

radio, turn the radio off to ensure a full 

charge.  

4.  Do not turn off the power supply or 

remove the battery when charging a 
battery.  

5.  Never charge a battery that is wet. Dry it 

with a soft cloth prior to charging. 

6.  The battery will eventually wear out when 

the operating time (talk-time and standby 

time) is noticeably shorter than normal 
performance.  It is time to buy a new 

battery.  

 
INITIAL USE  

New batteries are shipped uncharged from 
the factory. Charge a new battery for 5 hours 
before initial use. The maximum battery 

capacity and performance is achieved after 
three full charge/discharge cycles. If you 

notice the battery power runs low, please 
recharge the battery.  
 

 

TO PROLONG BATTERY LIFE: 

1.  Battery performance will be greatly 

decreased at a temperature below 0C . A 
spare battery is necessary in cold 

weather. A cold battery is unable to work 
in this situation will work when back to  
room temperature.   

2.  Dust on the battery contacts may cause 

the battery to not work or charge. Please 

use a clean dry cloth to wipe them before 
attaching the battery to the radio.  

Содержание UV-81C

Страница 1: ...ex 20 Ch20 Simplex 21 Ch21 Simplex 22 Disabled Telemetry Only 23 Disabled Telemetry Only 24 Ch24 Simplex 25 Ch25 Simplex 26 Ch26 Simplex 27 Ch27 Simplex 28 Ch28 Simplex 29 Ch28 Simplex 30 Ch28 Simplex 31 Ch1 Repeater Input 32 Ch2 Repeater Input 33 Ch3 Repeater Input 34 Ch4 Repeater Input 35 Ch5 Repeater Input 36 Ch6 Repeater Input 37 Ch7 Repeater Input 38 Ch8 Repeater Input 39 Ch39 Simplex 40 Ch40...

Страница 2: ... through setting options 1 Squelch level default 3 0 open Setting with 9 needs the strongest sig nal 2 Saving mode battery save mode 1 to 4 Receive sleep ratio for receive the higher number increases the re ceive sleep time but you may miss the first few syllables before the receiver operates 1 1 1 2 1 2 3 1 3 4 1 4 3 VOX Select Voice Activated Swtch level off 1 to 10 where 1 is low micro phone se...

Страница 3: ...ay sound loud and distorted simply adjust your radio volume for best performance When an older wideband radio receives a signal from a new narrowband radio the speech may sound quiet simply adjust your radio volume for best performance Depending on how close your receiving radio is to another transmitting radio there can be interference from the transmitting radio if it is using a channel adjacent...

Страница 4: ...e under room temperature to reduce self discharge Install the antenna as shown as below NOTE When installing the antenna don t rotate it by its top Hold it by its base and turn clockwise Don t over tighten If you use an external antenna make sure the SWR is about 1 5 1 or less to avoid damage to the transceiver s final transistors NEVER TRANSMIT WITHOUT AN ANTENNA FITTING ANTENNA 10 1 When your ra...

Отзывы: