(38) Delay time of side tone elimination in communication through repeater (RPT-RL) - Menu No.37
With this function you have the confirmation that the repeater has transferred the signal. You can choose
amongst: OFF 1,2,3,4,5,….10 to set the delay time.
(39) Display mode at the turning on (PONMSG) Menu No.38
With this function you can set the display mode when the radio is turned on. Available options:
•
FULL:
full frequency character is displayed.
•
MSG: UV-5G is displayed.
(40) Roger beep (ROGER) - Menu No. 39
When the PTT is released, the radio will beep to confirm to other users that you have finished your transmission
and that they can start talking.
(41) Reset (RESET) - Menu No.40
With this function you can reset the transceiver to the factory-programmed settings and parameters. After that,
you can set the desired functions.
There are two types of reset:
•
VFO:
Menu Reset
•
ALL:
Menu and channel Reset
8. ON-LINE SERVICE AND SUPPORT
The Pofung website provides additional information about obtaining service or support for the Pofung line of
two-way radios and accessories. Visit:
FCC Licensing Information This pofung radio operates on Commercial/ Land Mobile frequencies which require a
license from the Federal Communications Commission (FCC) for business, personal, education and recreational
use. To obtain forms, call the FCC forms hotline at: 1-800-418-3676 or go to http://www.fcc.gov For questions
concerning commercial licensing, contact the FCC at 1-888CALL-FCC (1-888-225-5322).
Appendix A.
– Trouble shooting guide
Phenomena
Analysis
Solution
You cannot turn on the radio.
The battery may be installed improperly.
Remove and reattach the battery.
The battery power may run out.
Recharge or replace the battery.
The battery may suffer from poor contact caused by
dirty or damaged battery contacts.
Clean the battery contacts or replace the
battery.
During receiving, the voice is weak
or intermittent.
The battery voltage maybe low.
Recharge or replace the battery.
The volume level may be low.
Increase the volume.
The antenna maybe loose or maybe installed
incorrectly.
Turnoff the radio, and then remove and
reattach the antenna.
The speaker maybe blocked.
Clean the surface of the speaker.
You cannot communicate with
other group members.
The frequency or signaling type maybe inconsistent
with that of other members.
Verify that your TX/RX frequency and
signaling type are correct.
You may be too far away from other members.
Move towards other members.
You hear unknown voices or noise.
You may be interrupted by radios using the same
frequency.
Change the frequency, or adjust the squelch
level.
The radio in analog mode maybe set with no
signaling.
Request your dealer to set signaling for the
current channel to avoid interference
You are unable to hear anyone
because of too much noise and hiss.
You may be too far away from other members.
Move towards other members.
You may be in an unfavorable position. For
example, your communication may be blocked by
Move to an open and flat area, restart the
radio, and try again.
