6.
BATTERY
CHARGING:
Use only the charger specified by the manufacturer. The charger’s LED indicates the charging
progress.
CHARGING
STATUS
LED
INDICATION
Standby (no-load)
Red LED flashes,while Green LED glows
Charging
Red LED solidly glows
Fully Charged
Green LED solidly glows
Error
Red LED flashes,while Green LED glows
Please follow these steps:
1. Plug the power cord into the adapter.
2. Plug the AC connector of the adapter into the AC outlet socket.
3. Plug the DC connector of the adapter into the DC socket on the back of the charger.
4. Place the radio with the battery attached, or the battery alone, in the charger.
5. Make sure the battery is in good contact with the charging terminals. The charging process
initiates when the red LED lights.
6. The green LED lights about 4 hours later indicating the battery is fully charged. Then remove the
radio with the battery attached or the battery alone from the charger.
7.
BATTERY
INFORMATION:
7.1.
INITIAL
USE
New batteries are shipped uncharged fully from the factory. Charge a new battery for 5 hours
before initial use. The maximum battery capacity and performance is achieved after three full
charge/discharge cycles. If you notice the battery power runs low, please recharge the battery.
WARNING:
‐
To
reduce
the
risk
of
injury,
charge
only
the
battery
specified
by
the
manufacturer.
Other
batteries
may
burst,
causing
bodily
injury
and
property
damage.
‐
To
avoid
risk
of
personal
injury,
do
not
dispose
of
batteries
in
a
fire!
‐
Dispose
of
batteries
according
to
local
regulations
(e.g.
recycling).
Do
not
dispose
as
household
waste.
‐
Never
attempt
to
disassemble
the
battery.
