90321 Banzai
4
SLIDE ‘N SOAK SPLASH PARK™ SETUP DIAGRAM
Water Spraying
Hose Assembly
Blower Ground
Stakes
Water Slide
Ground Stakes
Blower Motor
Water Spraying
Hose Assembly
Water pressure can vary dramatically between cities. Please read
the following to answer some common questions.
Areas of LOW WATER PRESSURE:
• For maximum performance, it is recommended to use a
5/8 in (1.6 cm) diameter garden hose.
• If water does not arch on the slide or shoot properly. This is
usually due to low water pressure, make sure the water is on all
the way. As long as the slide is getting wet, it will be fun to use.
• Long hoses reduce water pressure: The longer the hose, the
farther the water travels from the faucet thus reducing water
pressure. In areas of low water pressure, this could affect
performance of the water spray. Try using a shorter hose if you
have one.
Areas of HIGH WATER PRESSURE:
• If water shoots over the slide, adjust the faucet to lower the
water pressure. It is important that the water lands on the slide
to keep it wet and slick.
IMPORTANT WATER PRESSURE
AND OPERATING INFORMATION
1. Wet the inflatable before connecting the garden hose to the hose
adapter.
2. Locate the end of the Water Spraying Hose Assembly that should be
attached to the inflatable.
3. Attach the screw cap on the hose assembly to your garden hose.
4. Turn on the water slowly. It may take a few moments until water begins
to spray.
5. Adjust the water pressure so that the water sprays on the sliding
surface of the inflatable, keeping the inflatable wet.
CONNECTING THE WATER HOSE
