90320 Banzai
4
1. Wet the inflatable before connecting the garden hose to the hose adapter.
2. Locate the end of the Water Spraying Hose Assembly that should be
attached to the inflatable.
3. Attach the screw cap on the hose assembly to your garden hose.
4. Turn on the water slowly. It may take a few moments until water begins to
spray.
5. Adjust the water pressure so that the water sprays on the sliding surface of
the inflatable, keeping the inflatable wet.
Follow Anchoring Instructions
User must read and follow anchoring instructions to ensure the proper: number of
anchors used, soil conditions, and stake installation.
Stakes are to be driven straight down
until the top of the stake is below
ground level. Do not drive stakes at
an angle. For best holding strength,
drive stakes into hard, dry soil. In
loose or wet soil, or both, stake
holding strength will be reduced.
ANCHORING THE INFLATABLE
Water pressure can vary dramatically between cities. Please read the following to
answer some common questions.
Areas of LOW WATER PRESSURE:
• For maximum performance, it is recommended to use a 5/8 in (1.6 cm)
diameter garden hose.
• If water does not spray sufficiently, it is usually due to low water pressure.
Make sure the water is on all the way; as long as the slide is getting wet, it
will be fun to use.
• Long hoses reduce water pressure: The longer the hose, the farther the water
travels from the faucet, thus reducing water pressure. In areas of low water
pressure, this could affect performance of the water spray. Try using a shorter
hose if you have one.
Areas of HIGH WATER PRESSURE:
• If water shoots over the slide, adjust the faucet to lower the water pressure. It
is important that the water lands on the slide to keep it wet and slick.
IMPORTANT WATER PRESSURE
AND OPERATING INFORMATION
Yes
No
Stake Angle
CONNECTING THE WATER HOSE
Water Spraying
Hose Assembly
Blower Ground
Stakes
Water Slide
Ground Stakes
Blower Motor
Water Spraying
Hose Assembly
GUSHING GEYSER WATER PARK™ SETUP DIAGRAM
