BANNON
Maintenance
5500-Lb. Capacity Multi-
Directional Pallet Jack
OWNER'S MANUAL
Maintain the product by adopting a program of conscientious repair and maintenance in
accordance with the following recommended procedures. It is recommended that the general
condition of any tool be examined before it is used. Keep your tool in good repair. Keep handles
dry, clean, and free from oil and grease. The following chart is based on a normal operation
schedule.
Maintenance Interval
Maintenance Point
Daily inspection and maintenance of the pallet jack is
required, especially for the wheels and the axles.
Remove thread or rags on the wheel or axle if any are
detected. Unload and lower the forks to the lowest
position after every job is finished.
Daily before operating
Use motor oil or grease to lubricate all movable parts.
Remove the air by moving the control handle to the
LOWER position, then pump the handle up and down
several times. Repeat this process until the forks lift
as intended.
Check the oil level every six months. The oil can be
hydraulic oil, motor oil, or break oil.
After every 6 months operating
The pump capacity is about 14.37 oz. (0.425 liters).
When changing or adding oil, fill the tank through
Troubleshooting
&
WARNING:
the oil plug hole with 7.78 oz. (0.23L) of new
hydraulic jack oil.
Do not attempt to repair the pallet jack unless you are trained and authorized to do so.
Failure
Possible Cause
Corrective Action
The forks cannot be
There is not enough hydraulic
raised up to the
Add more oil.
maximum height.
oil in the pump.
Missing hydraulic oil.
Fill with oil.
The forks cannot be
The oil has impurities.
Change the oil.
raised.
Air has been introduced into
the hydraulic oil.
Bleed the air.
The piston rod (D135N) or pump
body is deformed, resulting from Replace the piston rod (D135N)
a partial load slanting to one
or pump body.
side or overloading.
The forks cannot be
The fork was kept in the high
Keep the fork in the lowest
lowered.
position for a long time with the position when not in use.
piston rod exposed, causing
Ensure the rod is properly
rusting and jamming of the rod. lubricated.
The adjusting screw (D121 N) is Adjust the screw (D121 N). See page
not in the correct position.
9 for adjusting the control handle.
5 of 11
