Banner Q3XTBLD150-Q8, Инструкция по эксплуатации

Страница: 19 / 31

Method Action Result
Push Button Press TEACH to teach the sensor.
The sensor sets the switching threshold
and returns to Run mode.
Remote Input Single-pulse the remote input.
T
flashes briefly on the display
and the sensor returns to Run mode.
Table 6: Expected TEACH Behavior for Light Set
Condition TEACH Result Display
A valid condition is detected. Sets the threshold at a value less than the
taught
condition, as defined by the
value.
The current NSS displays.
The taught condition is at a low signal level. Sets the threshold at a percentage greater
than the value defined by the value.
The percent offset needed with the
presented target briefly displays, then the
current NSS displays.
The taught condition is darker than the
minimum signal value limit.
Sets the threshold at the minimum level.
Sets the sensor at the maximum detection
condition.
briefly displays, and then the current
NSS displays.
The taught condition is brighter than the
maximum signal value limit.
Sets the threshold at the maximum level
minus the
value.
The current NSS displays.
3.5.6 Dark Set
Dark set sets a switching threshold a user-selectable percent offset above the presented condition. Use the menu to set the
offset percentage. The default is 50%.
Threshold position
adjusted by
Manual Adjust
Sensor positions
threshold slightly above
the presented condition
Darkest
(no signal)
Most Light
(saturated
signal)
Output OFF Output ON
Condition
Presented
Figure 12. Dark Set (Light Operate shown)
Note: The sensor must be set to = to use the following instructions.
Note: To program the sensor using remote input, remote input must be enabled ( = )
1. Present the target.
Method Action Result
Push Button
Present the target. The sensor-to-target distance must be within the sensor's
range.
The target's value displays.
Remote Input
2. Start the TEACH mode.
Method Action Result
Push Button Press and hold TEACH for longer than 2 seconds.
and flash alternately on
the display. The DYN and WND indicators
flash.
Q3X Laser Contrast Sensor
www.bannerengineering.com - Tel: 763.544.3164 19