Banner DXM1200-X2, Инструкция по эксплуатации

Страница: 21 / 83

February 02, 2024
DXM1200-X2 Controller Instruction Manual
© Banner Engineering Corp. All rights reserved.
21
•
•
•
•
•
•
•
ISM radio board
DIP Switch
Bank 1
Button
LED
DIP Switch
Bank 2
1 1
ON ON
Antenna
2
3
4
2
3
4
Chapter Contents
MultiHop Radio DIP Switches ............................................................................................................................................................................ 21
Modbus Registers for the MultiHop Radio Board Module .................................................................................................................................. 23
DIP Switch Settings for the Performance Gateway Radio Module..................................................................................................................... 23
Modbus Registers for the Performance Gateway Radio Module ....................................................................................................................... 23
Plug the ISM radio into the I/O base board with the U.FL antenna connector closest to the SMA connectors. Typically, users
will not need to adjust the DIP switch settings on the physical radio modules.
For the DXM1200 models, set the radio options using the
LCD menu.
Button Operation
For DXM models without a LCD display, use the button
to bind the ISM radio. For models with a LCD display,
use the ISM menu to bind the radio.
LED Operation
The LED located on the ISM radio module indicates
power and communications traffic. ISM board LED
operations also display on the LED on the right side of
the I/O base board.
Solid green DX80 ISM radio LED indicates
power.
Flashing green MultiHop ISM radio LED
indicates operation.
Red and green combined: Communications
traffic and binding.
MultiHop Radio DIP Switches
MultiHop ISM radio devices are defined with R2, R4, and
R5 in the model number.
DXMxxx-xxR2 - MultiHop 900 MHz
DXMxxx-xxR4 - MultiHop 2.4 GHz
DXMxxx-xxR5 - MultiHop 900 MHz, 100 mW
DXMxxx-xxR9 - MultiHop 900 MHz, (Australia)
Making changes to the baud or parity settings requires that you make the same settings to the Modbus Client
Communications section within the DXM Configuration Software (Settings
› General.
Disabling the serial port disables the ISM radio in the DXM Controller. Selecting Transparent mode causes radio
communications to be slower and denies access to device I/O register data.
DIP switch settings
D1 Switches D2 Switches
Device Settings 1 2 3 4 1 2 3 4
Serial line baud rate 19200 OR User defined receiver
slots
OFF* OFF*
Serial line baud rate 38400 OR 32 receiver slots OFF ON
Serial line baud rate 9600 OR 128 receiver slots ON OFF
Serial line baud rate Custom OR 4 receiver slots ON ON
Parity: None OFF* OFF*
Parity: Even OFF ON
Continued on page 22
ISM Radio Board (ID 1)
Chapter 3