NOTE: For Window SET and Light SET, the maximum offset threshold percent is 90%.
Threshold position
adjusted by
Manual Adjust
Sensor positions
threshold a programmable
% offset below the
presented condition
Darkest
(no signal)
Most Light
(saturated
signal)
Output OFF
Output ON
Condition
Presented
Figure 6. Light SET (Light Operate shown)
Light SET and Manual Adjust
Moves switching threshold value up or down to make adjustments
•
Slide Mode switch to ADJ to enter Adjust mode
•
Press "+" to increase; press "-" to decrease
◦
GREEN display shows the switching threshold value
◦
2 seconds after adjustment, the GREEN display will flash 3 times to confirm
•
Slide Mode switch to RUN to complete operation
Follow these steps to perform a Light SET:
Note: TEACH Selection must be programmed to Lt SEt (see
Program Mode
on page 5)
1. Enter Adjust Mode
Method
Action
Result
SET Button 11
Set Mode switch to ADJ
Display: Red - Signal Level; Green -
Threshold
Remote Input 12
No action is required; sensor is ready
for Light SET method
2. SET Sensing Condition
11 SET Button: 0.04 seconds
≤
"Click"
≤
0.8 seconds
12 Remote Input: 0.04 seconds
≤
T
≤
0.8 seconds
DF-G1 Expert
™
Dual Display Fiber Optic Light Receiver
12
www.bannerengineering.com - tel: 763-544-3164
P/N 172436 Rev. C
