4. Apply the thermal tape to the bracket.
a) Turn sensor with bracket side faced up.
b) Peel the clear liner off the thermal tape.
c) Align and stick the thermal tape to the bracket with blue liner facing up.
Figure 5. BWA-BK-014 with the blue thermal tape liner facing up
5. Peel off the blue side of the tape.
6. Stick the bracket and sensor assembly to equipment.
7. Apply pressure for 30 seconds to improve adhesion.
Install the BWA-BK-012 and -014 Using a Flathead Screw
This example uses a QM30VT2 with BWA-BK-014 for demonstration. The same steps can be applied for a QM30VT1 with BWA-
BK-014 or a QM30VT2-SS-9M with BWA-BK-012.
1. Clean bracket and sensor.
2. Tap a M4 × 0.7 hole into the surface of the equipment you want to monitor.
3. Put the flathead screw into the countersunk hole of the bracket.
Figure 6. BWA-BK-014 with the flathead screw installed
4. Coat the threads in desired surface with the 410 series Loctite.
5. Screw the bracket into your drilled hole until snug.
6. Place sensor on top of the bracket so the four corner holes align and secure sensor to bracket with the provided screws
using a 2 mm Hex Allen wrench.
Figure 7. QM30VT2 mounted to the BWA-BK-014 bracket
Bracket Assembly for the QM30VT Sensor
2
www.bannerengineering.com - Tel: + 1 888 373 6767
P/N 213323 Rev. A
