Banner BBT-205, Инструкция по эксплуатации, Страница: 19 / 24

•
19
•
BBT-205
. Close the door and make sure the lever locks securely.
NOTE: For a clean tear, pull the paper along the edge of the plastic.
Do not pull the paper straight out of the printer.
Troubleshooting the Printer
If the tester is not connected to a 12-volt battery with at least 9 volts of
power or the paper sensor does not detect paper in the compartment dur-
ing the print process, the tester displays one of the error messages de-
scribed in the table:
Error Message Interpretation
INSERT PAPER
THEN PRESS

√ Verify that the paper is inserted correctly.
√ Insert a new roll of paper.
√
Verify that the paper sensor is clean and un-
damaged
VOLTAGE TOO
LOW TO PRINT
To print, the tester must be properly connected to a
vehicle battery having at least 9 volts.
√ Connect to a vehicle battery with enough volt-
age to enable printing.
√ Make sure that the clamps are connected prop-
erly: red clamp to the positive (+) terminal and
the black clamp to the negative (-) terminal.
√ Check that both sides of the clamps are mak-
ing contact with the terminals.
paper