BANLAW PRODUCT DATA SHEET
PRODUCT NAME
Doc ID: PRH-FMG-76 Version: 1.0
Page 14 of 14
Please ensure you have the latest version of this document.
Batteries used in this system contain lithium-thionyl chloride. Please follow appropriate
battery disposal or recycling practices for used batteries of this type.
8
TROUBLESHOOTING
If the Wireless Swivel stops transmitting vehicle
’
s information, please follow the below troubleshooting
guide.
ISSUE
POSSIBLE SOLUTION(S)
No LED activity
1.
Wireless Swivel is asleep, move assembly and observe red LED
flashes at 1.5 times / second. If there is still no LED activity,
then proceed to step 2.
No LED activity after
movement
2.
If the Wireless Swivel fails to activate after movement, reset
the Wireless Swivel using a magnet.
3.
Place a magnet on the magnet reset zone (see figure 2) and
remove rapidly. Observe red and green LEDs flash rapidly for a
second. Then no activity for approx. 6 seconds then red LED
flashes at 1.5 times / second.
No LED activity after reset
4.
If there is still no LED activity either the battery is discharged,
or the electronics has failed. Replace the electronic module.
Advanced or Xpress
controller fails to identify
the Wireless Swivel
5.
Observe Wireless Swivel LED activity and troubleshoot as per
steps 1 to 4. If the swivel is still not recognised, replace the
swivel.
6.
If the fault persists, troubleshoot the Advanced or Xpress
Controller as per Controller Installation and Maintenance
Procedure.
9
OPTIONAL ACCESSORIES & SPARE PARTS
Item/Description
Banlaw Part Number
Electronics module
BRTWSMA
Mechanical body 1.5”
BRT33WS01
Mechanical body 2”
BRT34WS01
Banlaw does not recommend nor endorse the use of non-genuine replacement
(spare) parts. The use of spare parts not endorsed by the product OEM is likely to
void a product warranty and may jeopardise the safety, performance/function,
reliability, and regulatory certifications/approvals of the product.
Banlaw makes no guarantees and assumes no liability for circumstances arising out
of the accuracy and completeness of third-party product specifications included
within this document. The verification, validation, and publishing of specifications
for any product remain the responsibility of the product OEM.
END OF DOCUMENT
Website
–
