1. Select the place of
installation. (Figure 1)
2. Affix the template below
inside the drawer.(Figure 2)
3. Cut and remove the area
indicated using your preferred
method. If door / drawer
thickness is more than 17mm you
will need to recess the back
of the drawer so the front will
finish flush with the face.
(Figure 3)
4. Drill appropriate sized
pilot holes and fit screws
from the inside of the drawer,
ensuring you do not drill
through the face of the drawer.
(Figure 4)
Included
1. Pull
2. Wood Screws
Not Included
IMPORTANT:
Please install this hardware in the following order to ensure its
warranty is not voided.
1. Install the hardware on raw/unfinished door/drawer using the
instructions provided.
2. Remove hardware (where possible) and store safely. Do not place
tape onto the hardware as this will damage the finish.
3. Paint / finish door.
4. Reinstall hardware.
Figure 2
Figure 3
Inside of drawer pictured
Figure 4
(1)
(2)
For number references please refer to
included items on reverse.
Figure 3 (recessed)
Inside of drawer pictured
(Drawer thickness great than 17mm)
Figure 1
