Page 12
For technical questions, please call 1-888-866-5797.
Item 64268
S
AFET
y
Op
ERA
TION
M
AINTENAN
c
E
S
ETU
p
Operating Instructions
Read the ENTIRE IMpORTANT SAFETy INFORMATION section at the beginning of this
manual including all text under subheadings therein before set up or use of this product.
Inspect Tool before use, looking for damaged, loose, and missing parts.
If any problems are found, do not use Tool until repaired.
Workpiece and Work Area Set Up
1. Designate a work area that is clean and well-lit.
The work area must not allow access by children
or pets to prevent distraction and injury.
2. Route the air hose along a safe route to reach
the work area without creating a tripping hazard
or exposing the air hose to possible damage.
The air hose must be long enough to reach
the work area with enough extra length to
allow free movement while working.
3. Secure loose workpieces using a vise or clamps
(not included) to prevent movement while working.
4. There must not be hazardous objects
(such as utility lines or foreign objects) nearby
that will present a hazard while working.
Loading the Tool
TO pREVENT SERIOUS INJURy FROM AccIDENTAL DIScHARGE, BEFORE LOADING:
• Wear ANSI-approved safety goggles with side shields.
Other people in the work area must also wear ANSI-approved impact safety goggles with side shields.
• Detach the air supply.
• Attempt to discharge the Tool into a piece of scrap wood to ensure that
it is disconnected and is incapable of driving any fasteners.
Note: pREVENT JAMS!
Empty magazine before loading nails/staples of different length. Press the Latch
and pull the Movable Magazine back to rear of Fixed Magazine to allow old nail/staple strip to be removed.
Loading Cleat Nails:
1. Press the Latch and pull the
Movable Magazine back.
2. Place a full clip of the desired size cleat nails (1-1/2"
to 2" long) in the Fixed Magazine
from the side
.
The head of the cleat nails should be inserted into
the notch on the Fixed Magazine. Up to 100 cleat
nails may be loaded in the Fixed Magazine.
3. Push the Movable Magazine forward
and secure in place with the Latch.
Loading Staples:
1. Press the Latch and pull the
Movable Magazine back.
2. Place a full clip of the desired size staples (1" to 2"
long) in the Fixed Magazine
from the top
. Up to
80 staples may be loaded in the Fixed Magazine.
3. Push the Movable Magazine forward
and secure in place with the Latch.
changing the Spacer
The Tool is equipped with a factory
pre-installed
Spacer for 3/4" Boards and an additional
uninstalled
Spacer for 1/2" Boards. To change the Spacer:
1. Disconnect the Tool from its air supply.
2. Empty the Magazine completely.
3. Attempt to discharge the Tool into a piece of
scrap wood to ensure that it is disconnected
and is incapable of driving any fasteners.
4. Set the Tool on its side to expose the three Screws.
5.
Screw
Spacer
Remove the three Screws.
Then remove the current Spacer.
6. Align the three mounting holes in the desired
Spacer with the three threaded mounting holes.
7. Secure the Spacer to the Tool,
using the three Screws.
