Satellite installation
You can install or update tuned satellite channels which, for example, have been moved
by the broadcaster. Follow on-screen instructions.
Install satellites
This television has two built-in satellite DVB-S/DVB-S2 tuners.
You can install up to four satellites (four LNBs) on the television. Select the exact number
of satellites you wish to install at the start of the installation. This will speed up the
installation.
Unicable
You can use a Unicable system to connect the antenna dish to the television. You can
select Unicable for one or for two satellites at the start of the installation.
Start the installation
Make sure your satellite dish is connected correctly and is perfectly aligned before you
start the installation.
1. Press
, highlight
Settings
and press the
centre
button.
2. Highlight
Channels
and press
.
3. Highlight
Satellite Installation
and press the
centre
button.
4. Enter your child lock pin code if necessary.
5. Select
Search for Satellite
.
6. Select
One Tuner
or
Two Tuners
. The television has 2 built-in satellite tuners.
Make your selection according to how many satellite dish cables you have
available.
7. Select
Next
.*
8. Select
Search
. The television will search for the satellites available on the
alignment of your antenna dish. This may take a few minutes. If a satellite is
found, its name and reception strength are shown on-screen.
9. If the television shows the satellite(s) you want, select
Instal
l. If the television
does not find the satellite(s) you expect to find, the dish alignment may be
altered or a cable may be disconnected. You can select
Search Again
.
10. If a satellite offers
Channel Packages
, the television will show the available
packages for that satellite. Select the package you need.
11. Select
Next
. Some packages offer a
Quick
or
Full
install for their available
channels, select one or the other. The TV will install the satellite channels and
radio stations.
12. To save the satellite setup and installed channels and radio stations, select
Finish
.
*Before you start searching for satellites, you can change or check the installation
settings. See
Satellite installation settings
in this chapter.
Satellite installation settings
The satellite installation settings are preset according to your country. These settings
determine how the television searches and installs satellites and its channels. You can
always change these settings if you start the satellite installation and follow on-screen
instructions. On the screen where you can start searching for satellites, you can also
make settings for satellite installation.
You can select the number of satellites you want to install or select one of the Unicable
systems. When you select Unicable, you can choose the User band numbers and enter
the User band frequencies for each tuner.
Homing Transponder and LNB
: On some markets, you can adjust the advanced
settings for homing transponder and each LNB. Only use or change these
settings when a normal installation fails. If you have a non-standard
79
Содержание beovision 14-40
Страница 1: ......