Bang & Olufsen BeoLab 4000, Руководство пользователя

Страница: 6 / 12

6
C O N N E C T I O N S
The socket panel is located on
the rear of the BeoLab 4000.
Use this illustration and the
graphics imprinted on the soc-
ket panel for reference.
You may connect more than
one pair (as many as ten pairs,
in fact) of BeoLab 4000
speakers to your system. You
just have to run a Power Link
cable from speaker to speaker.
Remember though, to set the
LINE • L • R switch to the proper
position for the left- and right-
hand speakers, respectively. Connect the BeoLab 4000 to
your audio (or video) system
using the enclosed 8-pin Power
Link cable.
Plug one end into one of the
sockets marked POWER LINK
on the BeoLab 4000, and the
other end into either of the
two sockets marked POWER
LINK on the audio/video system
(please refer to the setting-up
guide for that system).
The switch marked LINE • L • R
must be set to either
L or R :
L for the left-hand speaker/
sound channel
R for the right-hand speaker/
sound channel
To avoid cables running from
both loudspeakers to your sys-
tem you may loop the signal
through from speaker to
speaker using the second socket
marked POWER LINK on one of
the BeoLab 4000, as illustrated.
You can, of course, also connect
one BeoLab 4000 loudspeaker
to each of the sockets on the
system.
Connection to Bang & Olufsen products
LINE
connection
LINE • L • R
switch
Power Link
connections
Connection
to the mains
POWER
1 2
LINK
LINE
L
R