3.2 Adjustments
Adjustments
Information
Depending on the repair there might be different kinds of adjustments/alignment
to be performed, after maintenance of the product.
Some adjustments have to be done with the
ServiceTool
.
Adjustments or calibration is necessary when the following modules are replaced:
PCB30, Digital Sound Engine
- when backup function
is
possible:
-
Restore product data from the data backup
-
Calibration of the amplifier (done automatically)
PCB30, Digital Sound Engine
- when backup function
is not
possible:
-
Restore product data from factory data (ID Restore)
-
Calibration of the amplifier (done automatically)
PCB35, Amplifier
:
-
Calibration of the amplifier
PCB89, Wireless Power Link Rx
- when backup function
is
possible:
-
Restore product data from the data backup
-
Connecting speaker wirelessly
PCB89, Wireless Power Link Rx
- when backup function
is not
possible:
-
Order a pre-programmed PCB89, Wireless Power Link Rx
-
Connecting speaker wirelessly
Speaker units
:
-
Calibration of speaker units
PCB30, Digital Sound Engine
Backup/Restore
This function is used when PCB30, Digital Sound Engine is replaced and it is still
possible to communicate with the old module. The following data is handled:
-
ID number
-
Serial number
-
Type number
-
Item number
-
Calibration of speaker units
-
Calibration of the amplifier
-
Product settings
-
Wireless data
-
A new calibration of the amplifier is performed again.
Connect ServiceTool, launch
BeoLab 20
and follow the procedure under
Repair.
Содержание BeoLab 20
