Bang & Olufsen BeoCenter 6-23, Справочник

Страница: 32 / 68

32
>> Set up your television
Aerial and mains connections
When you set the television up on its own,
simply connect the TV aerial to the TV socket
and a FM aerial to the socket marked FM and
connect the television to the mains as shown
to the right.
If your television is equipped with the
optional DAB module, you must connect a
DAB aerial also.
When using a DAB aerial …
– Use the DAB AERIAL ADJUSTMENT menu,
described on page 57, to find out where to
place your aerial. The menu lets you know how
strong the DAB signal is.
– Make sure that you hang or mount the aerial
vertically.
If you are going to connect speakers, an audio
system or any other equipment to the television,
do not connect it to the mains yet!
The supplied mains cord and plug are specially
designed for the television. If you change the plug
or in any way damage the mains cord, it will affect
the TV picture adversely!
When connections are complete and the cables
have been secured as described on this page,
switch on the mains. A tiny, red light appears
below the screen. The system is in standby mode
and ready to be used. If your television is set up
on its own, you can now tune in programs as
explained in the chapter
‘First-time setup of your
television’ on page 14.
Your television was designed to be left in standby
mode when not in use. Therefore, to facilitate
remote control operation, it is essential that you
do not disconnect it from the mains. The
television can only be switched off completely, if
you disconnect it from the mains.
IMPORTANT! All the cables must be fastened to
the television using the enclosed cable tier as
shown.
When you have made all the connections and
fastened the cables, mount the cable cover again.
A B C
FM
DAB
TV