B&R 5PC600.SE00-00, Руководство пользователя

Страница: 266 / 594

266
Software • BIOS options
Automation PC 620 with 945GME N270 CPU board User's Manual V 1.10
When these "preliminaries" are finished, BIOS seeks an operating system in the data storage
devices available (hard drive, floppy drive, etc.). BIOS launches the operating system and hands
over control of system operations to it.
To enter BIOS Setup, the DEL key must be pressed as soon as the following message appears
on the monitor (during POST):
"Press DEL to run SETUP"
1.2.1 BIOS setup keys
The following keys are enabled during the POST:
The following keys can be used after entering the BIOS setup:
Figure 117: X945 - BIOS diagnostics screen
Key Function
ESC The system RAM check can be skipped by pressing ESC.
Del Enters the BIOS setup menu.
F12 Using the F12 key, you can boot from the network.
F11 Cues the boot menu. Lists all bootable devices that are connected to the system. With cursor
↑
and
cursor
↓
and by pressing <ENTER>, select the device from which will be booted.
<Pause> Pressing the <pause> key stops the POST. Press any other key to resume the POST.
Table 165: X945 bios-relevant keys at POST
AMIBIOS(C)2005 American Megatrends, Inc.
[APC7R110] Ber Rainer
Industrie-Elektronik L1.10
Serial Number : 316862
CPU : Intel(R) Atom(TM) CPU N270 @ 1.16GHz
Speed : 1.60 Ghz
Press DEL to run Setup
Press F11 for BBS POPUP
The MCH is operating with DDR2-533/CL4 in Single-Channel Mode
Initializing USB Controllers .. Done.
1016MB OK
USB Device(s): 2 Hubs
Auto-Detecting Pri Slave...ATAPI CDROM
Pri Slave : DW-224E-A V.RA
Auto-Detecting Sec Slave...IDE Hard Disk
Ultra DMA Mode-2
Sec Slave : ST980817AM 3.AAB
Ultra DMA Mode-5, S.M.A.R.T Capable and Status OK
Auto-detecting USB Mass Storage Devices ..
00 USB mass storage devices found and configured.